In this article we will attemt
to explain the use and manufacture of a powerful blow-gun and
making darts for the gun.
(The possestion of the
blow gun described in this article IS a felony. So be carefull
where you use it. I dont want to get you all busted.)
Needed:
1. Several
strands of yarn (About 2 inches a piece)
2. A regular pencil
3. A 2 1/4 inch long needle, hopefully with a beaded head.
If not obtainable, wrap tape around end of needle.
4. 2-3 1/4 foot pipe. (PVC or Aluminum) Half a inch in diameter
Constructing the dart.
1st- Carefully
twist and pull the metal part (Along with eraser) of the pencil
till it comes off.
2nd- Take Pin and start putting
about 5-7 Strands of yarn on the pin. Then push them up to
the top of the pin. But not over the head of the pin (or the
tape).
3rd- Push pin through the
hollow part of the head where the pencil was before.
4th- That should for a nice
looking dart. (see illustration)
####\
#####>>>>>-----
####/
# is the yarn
> is the
head of the pencil
- is the
pin it-self
Using the Darts
1st- Now take
the finished dart and insert it in the tube (if it is too
small put on more yarn.)
2nd- Aim the tube at a door,
wall, sister, ect.
3rd- blow on the end of the
pipe.
